Plexigel Protector Top Coat 15ml - A clear, high-gloss, protective top coat

Product Code: PLEX004

Added to your Wish List

• Instructions for use

  DIRECTIONS FOR USE

  • Perform Preparation of the nail plate and apply PLEXIGEL Bonder to the natural nail. Cure for 10 seconds in the LED Lamp.
  • Apply two layers of PLEXIGEL Shaper to the nail, sealing the free edge after application.
  • Cure each layer for one minute in the LED Lamp.
  • Apply PLEXIGEL Protector Top Coat and cure in the LED Lamp.
  • If using Shellac, skip Protector Top Coat and Shellac Base coat and apply 2 layers of Shellac / Gel Polish Colour. Cure each layer for one minute in LED Lamp. Finish with a layer of Gel Top Coat.

• Additional Info

  PERFORM A MANICURE. 1. Wash their hands with soap and running water for 20-30 seconds and towel dry. 2. Massage Hand Cleanser into the client’s hands. 3. If necessary, remove any existing nail color from the natural nail using an acetone-based polish remover and a plastic-backed lint-free pad. 4. If necessary, trim the length from each nail, using nail clippers. 5. Shape the free edge of each nail with a fine 240-grit file 6. Gently slide a cuticle pusher along the nail plate toward the proximal nail fold (cuticle area) and along each lateral fold (sides of nail) to lift and loosen any cuticle from the nail plate.*7. Gently guide a curette along the nail plate to remove non-living tissue on the nail. 8. If necessary, use a manicure nipper to carefully remove any loose pieces of skin or hangnails. Remove the surface shine with a Buffer. Then scrub the nail plate clean with nail cleanser.

  BONDER - Apply Bonder 1. Roll the bottle gently to blend. 2. Apply a thin layer of Bonder to all five nails, sealing the edge after each application. Always leave a tiny free margin around the perimeter of the nail to avoid the skin. 3. Cure for 10 seconds in the LED Lamp. Do not remove the top film after removing nails from the lamp.

  SHAPER -Apply a thin, even layer of Shaper to the natural nail, sealing the free edge after application. Always leave a tiny free margin around the perimeter of the nail to avoid the skin. 2. Apply to all five nails and cure for one minute in the LED Lamp. Do not remove the top film after removing the nails from the lamp. 3. Apply a second layer of shaper to prefect the shape, using a light touch to float the gel over the nail. a. Flash cure two fingers at a time to prevent the gel from running, 4. Apply shaper to all five nails and cure for one minute using LED Lamp

  PROTECTOR TOP COAT Use to seal and protect clear enhancements or prior to applying Long Wear Polish. 1. Roll the bottle gently to blend. 2. Apply a layer of Protector Top Coat to all five nails sealing the free edge after application. 3. Cure for one minute in the LED Lamp 4. Lightly wipe to remove top film with lint-free pad or cosmetic sponge saturated with 99% Isopropyl Alcohol.

  ADD COLOR